Harvesting systems
-
Tumble Trimmer Harvester
Remove leaves almost soundless without electricity. Fresh buds are cut up (3 - 5 cm) and put on the removable grid. If you put the lid on top and crank the handle, the buds roll over the grid, slightly brushed against it. Underneath the grid is a fine wire which quickly starts to vibrate and cut the leaves which pop out from under the grid. For a finer result the wire can be run closely against the grid - or a few milimeters underneath the grid for a coarser cut. Ø 43 cm 45 cm hoch 4,2 KG The Tumble Trimmer cuts up to 20 g of dry weight in 10 - 20 seconds, i.e. 20 - 30 cranks. The grid is removable and the cut up buds can right be scattered on the dry rack. -
Twister T2 Trimmer (wet)
Twister T2 Trimmer Harvest Machine -
Trimpro Rotor XL, seal rubber
Trimpro Rotor XL, seal rubber -
Trimpro Automatik XL, seal rubber
Trimpro Automatik XL, seal rubber -
Trimpro Rotor, seal rubber
Trimpro Rotor, seal rubber -
Trimpro Rotor XL, fingers leather
Trimpro Rotor XL, fingers leather -
Trimpro Rotor XL, chute
Trimpro Rotor XL, chute -
Trimbox Motor
Spare Motor for Trimbox (trim0005) and Trimbox Workstation (trim0006set) -
Trimpro Automatik XL Grate, 7/16', large slots
Trimpro Automatik XL Grate, 7/16', large slots -
Trimpro Automatik XL, Exit Bent
Trimpro Automatik XL, Exit Bent